YAG Laser Power Supply WN8-JG Laser Power Supply

WorkingEnvironment

1．Ambient Temperature 20 C ~30 C

2．Relative Humidity not High at 80 %

3．Usage Power Supply Single Phase220V±20％，50Hz

Single Phase110V±10％，60Hz

Run mode

between rest load Continuous Run mode ， use every Continuous Workingten Minute clock between rest ten Minute clock for suitable 。

Coolingstrong system wind cycle Cooling 。

Power Supply week surround response remain 20mm above of empty between 。Guarantee Heat Dissipation and Circuit positive common Working 。

one 、Main Technical Parameters

Supply Voltage：AC220V±20 % AC110V±10 %

Energy Storage Capacitor：100μF/1400V

Input Power：1800W

Output Power：1500W

Output Voltage：DC700-1000V

Remarks：Customizable Output Voltage DC0-1000V of Power Supply。

Match Controller：WK4C、WK7C、WK5C2、WK10C

two 、Product Features

adopt Main Power and Pre-ignition Separate design ，Guarantee Product Stable Performance，Suitable at any what Xenon Lamp.

Wiring Simple，Easy Installation，Metal Shell design ， make Power Supply Get more Effective of Protection。

three 、Dimensions：270*210*130mm( Long * Wide * High )

common see Fault row except

1． press below Working Switch not count number not out Light

this Power Supply place match Controller is accordingto country mark design ， first second out Light has 2Second around of extend h ， so response press live Working Switch not Discharge， etc count number Device count number h immediately can out Light， meanwhile has Prompt sound 。 for done Operation safe ， first one point out Light please Used for Test Machine WorkingStatus， not need direct connect Used for Treatment。

2． press accurate prepare key ，Display Pre-ignition Error

this phenomenon is point Lamp not can success， first need look Lamp is no completegood 。 general via Handpiece Output window immediately can look to ， if Lamp break can look to Lamp has water ， if Lamp leak Gas appearance above is look not out come of 。 can change one Piece new Lamp test one below 。 still has is High Voltage Insulation do of notgood 。 cause High Voltage not enough ， heavy point check Lamp positive Pole of connect Line， especially its is Lamp positive Pole and Power Supply Output Line of Connection division 。 can use three layer heat shrink tube between irrigate input 703 glue 。 Lamp Electric Pole distance cavity body of distance also should end maybe far one some ， meanwhile need Insulationgoodgood 。

3． press accurate prepare key ，Systemreturn heavy new Start

this phenomenon is High Voltage Insulation notgood and Interference problem ， first notice Working Switch， end amount Usage pin step Switch， not need Usage Handpiece Switch。

if must Usage Handpiece Switch， please notice Handpiece Switch and cavity body of distance response end maybe far ， same time response add can reliable of Insulation。 then press first two Type situation check 。 meanwhile check High Voltage Output Line distance Control Line etc its it Line response has certainly of distance ， not can all one up walk Line。

4．Display Working ， can count number however not out Light

check Main Power Board stand Board above of Small Lamp is no can bright 。 positive common situation can with out Light yet h bright h extinguish 。 such as not positive common please will row Line two Head to adjust heavy insert ， and check Controller is no for match Set Controller(Controller above has N2 character like )。